Figure-rise Kamen Rider OOO TaToBa Combo: Build Tips
By Newtype: Gundam Model Kits / Gunpla / Paint / Tools | Published: 2026-11-03
Category: Product Reviews
Get a clean, poseable Figure-rise Kamen Rider OOO TaToBa Combo with this step-by-step build order, from chest crest care to a stable rider kick pose.
Quick answer
Build the TaToBa Combo in sub-assemblies, protect the tampo-printed chest crest from the start, and test the rider kick pose before you lock in joints. That order keeps the Figure-rise Kamen Rider OOO clean and poseable without rework.
Why the chest crest changes your build order
The TaToBa chest crest is reproduced with a tampo-printed part rather than separate colored pieces. That is great for accuracy, but it means the crest is a finished surface, not a part you can sand or scrape. Treat it as a handling hazard from the moment you cut it free.
Work over a clean tray and keep the crest bagged until the torso is otherwise complete. If you plan to topcoat, test on a runner first rather than spraying the printed face directly.
Where this kit rewards patience and where it does not
This is a Figure-rise kit, so the build is approachable, but the combo-change gimmick and printed crest mean the visible torso deserves more care than the limbs. Spend your cleanup time on parts you will actually see in a rider kick pose: the chest, shoulders, and outer legs.
Skip heavy modification unless you have a clear goal. The kit includes accessories such as Traclaws, and those are better used for posing than for permanent glue work on a first build.
Step-by-step TaToBa build order
- Wash and sort runners: Give the runners a quick lukewarm rinse and lay them out by letter before cutting. Common mistake: cutting parts as you find them, which makes the printed crest easy to lose or scratch. Keep the crest runner in its bag until the torso is ready.
- Build the torso sub-assembly first: Assemble the chest and waist without forcing joints, and dry-fit the crest before pressing it home. Checkpoint: the crest should sit flush without flexing the surrounding plastic.
- Clean nubs before assembly, not after: Trim nubs with flush cutters and scrape lightly with a hobby knife, then test-fit each joint. Common mistake: sanding near the printed crest, which can dull the tampo print. Mask or remove the crest before any sanding near the chest.
- Assemble limbs and test range of motion: Build arms and legs, then move each joint through its full arc before adding armor. Checkpoint: if a joint feels tight, ease it now rather than after the armor is on.
- Dry-fit the Traclaws and hands: Test the Traclaws on the wrists and swap hands before committing to a pose. Common mistake: forcing a hand onto a tight peg, which can crack the wrist. Warm a tight peg slightly with your fingers rather than forcing it.
- Set the rider kick pose with a support plan: Balance the figure on one leg, angle the raised leg and arms for a clear silhouette, and use a stand or hidden support if the ankle rolls. Checkpoint: the pose should hold for a full minute without drifting.
- Topcoat and detail last: If you use panel liner or a matte topcoat, apply it after posing tests and keep it off the printed crest unless you have tested compatibility. Common mistake: topcoating before final cleanup, which traps dust and smudges. Test any topcoat on a runner scrap before touching the crest.
Product facts
- Figure-rise Kamen Rider OOO TaToBa Combo: The TaToBa chest crest is reproduced with a tampo-printed part, and the kit includes accessories such as Traclaws. Plan handling and cleanup around the printed crest, and dry-fit the Traclaws before final posing so the accessories do not stress the wrists.
Figure-rise Kamen Rider OOO TaToBa Combo
