What to Expect from the Unpainted Ultraman Kit
The 1/6 Scale Ultraman Suit Ver 7.3 is an unpainted ABS model kit that stands about 12.6 inches (32 cm) tall. It comes with pieces to build Ultraman Ver 7.3, plus two Specium energy fists, two Specium steel blades, and two rifles. Because the kit is unpainted, you have full control over the final color scheme and finish. This guide covers the basic steps to prepare, paint, and assemble the figure for a clean display.
Product Facts for Your Bench
- 1/6 Scale Ultraman Suit Ver 7.3 (Unpainted): The kit is made of ABS plastic and is supplied unpainted. It includes pieces for Ultraman Ver 7.3, 2 Specium energy fists, 2 Specium steel blades, and 2 rifles. ABS plastic requires surface preparation (washing and priming) for paint adhesion. Knowing the included parts helps you plan your painting sequence and which areas to mask.

1/6 Scale Ultraman Suit Ver 7.3 (Unpainted)
Practical Steps for Painting
The following sequence works for most unpainted ABS model kits. Adapt it to your preferred paints and tools.
- Wash the parts: Clean the ABS runners and loose parts with mild soap and water to remove mold release agents. Let them dry completely before priming.
- Prime the surface: Use a primer suitable for ABS plastic. A light, even coat helps paint adhere and reveals any surface imperfections you may want to sand.
- Paint in sub-assemblies: Keep the torso, arms, head, and accessories separate. This makes it easier to reach tight areas and avoids rubbing fresh paint.
- Apply your chosen colors: Use acrylic, enamel, or lacquer paints. Thin them appropriately for your airbrush or brush. Let each coat dry before adding the next.
- Add decals or details: If you plan to add markings, apply them after the base color is fully cured. A gloss coat before decals helps them slide into place.
- Seal the finish: A clear topcoat (matte, satin, or gloss) protects the paint and unifies the sheen. Test on a spare part first.
Assembly After Painting
Once all painted parts and topcoat are fully cured, assemble the kit according to the included instructions. The ABS plastic should fit together as intended, but take care not to force painted joints—scrape paint away from peg holes if needed to avoid stress marks. The finished figure stands about 12.6 inches tall and can be posed with the Specium steel blades, rifles, and energy fists.
What the Supplied Information Does Not Confirm
The product record does not specify recommended paint brands, drying times, or assembly difficulty. It also does not confirm whether the ABS plastic is pre-colored or requires painting on all surfaces. For best results, test your paint on a hidden area or spare part before committing to the final finish.

